Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

meggaring cable

Status
Not open for further replies.
vandasboy

vandasboy

Electrical
Joined
Jun 15, 2010
Messages
2
Location
CA
i have a 3 conductor 12 awg 600volt rated cable feeding a motor. the leads have been cleared at either end the grounds are still connected I meggared at 500volts and have 2000m ohms between wires and 5m ohms from each wire to ground is this a good cable?
 
Sort by date Sort by votes
I would say so, is there any reason why you would suspect otherwise? Are you getting ground faults?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

David Adeola
  • Locked
  • Question Question
Earth Leakages on Medium Voltage cable
Replies
6
Views
931
7anoter4
7anoter4
Imumahdi
  • Locked
  • Question Question
MV VFD Cable Length Concern
Replies
9
Views
790
jraef
jraef
vithanidevesh
  • Locked
  • Question Question
Parallel Cable imbalance load
2 3
Replies
47
Views
3K
waross
waross
Histor
  • Locked
  • Question Question
Space heater and PTC cable in one cable entry
Replies
2
Views
346
Gr8blu
Gr8blu
HenryOhm
  • Locked
  • Question Question
690V Motor Cable Insulation off Microgrid
Replies
1
Views
467
Gr8blu
Gr8blu

Part and Inventory Search

Sponsor

Back
Top