Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mechanica users

  • Thread starter Thread starter design-engine
  • Start date Start date
Status
Not open for further replies.
Wish you were closer Bart, however there is a guy I know that is pretty good, Len Discenza at DBAWorks, check out the site at http://www.dbaworks.com/ he does instructing for PTC.... Give him a call. I will send him an email as well.
 
Contact John Leahey, independent contractor/instructor.

www.simulationsolutions.com He taught a class that I took and he was very good.
 
Contact John Leahey, independent contractor/instuctor, www.simulationsolutions.com

He taught a class I took and he was good.
 
Status
Not open for further replies.

Similar threads

jasongBSME
  • Locked
  • Question Question
Converting from Pro/Mechanica to Creo Simulate
Replies
0
Views
801
jasongBSME
jasongBSME
T
Pro mechanica - create a mesh from imported points (nodes)
Replies
1
Views
24K
Twig Studio
T
A
Pro/Mechanica Material Assignment and Meshing for Assemblies
Replies
0
Views
6K
AMega
A
Tmoose
  • Locked
  • Question Question
Borrowing Mechanica license
Replies
0
Views
201
Tmoose
Tmoose
S
Contraints for Hydraulic Valve body - Pro-Mechanica
Replies
1
Views
3K
Fatiguester_FA
F

Part and Inventory Search

Sponsor

Back
Top