Mechanica Integrated Mode not working

[mit_joel]

I have Wildfire 2.0 and the analysis modules. I can run Mechanica in the seperate (looks really old school) mode, but I have no experience with that. When I try to run integrated mode, Wildfire only gives me the FEM options. Is there a way to activate the integrated mode? Any ideas?


Thanks.
Edited by: mit_joel

 

[Israr]

kindly search topics before creating new topc This very question has been asked and replied more than 20 times.


btw the reason is incorrect installation.


Israr

 

[mit_joel]

Israr,


Can you give me alittle help here. I have searched the key words that I can think of(including "incorrect installation") and read through a lot of other posts.


Thanks.


Joel

 

[mit_joel]

I finally found a sufficient answer by looking at other posts by you, Israr, where someone posted an actual response after you that was helpful.

 

[huynhthanhlich]

Hi mit-joel


Afteryou istall pro/e and pro/mechanica you have to replace mechanica to pro/e. You make link: C:\PTC\proeWildfire 2.0\bin\ptcsetup, u click next until window"Select the optional configuration steps you wish to perform" you add stick on row "configure orther product interoperability", and click next. In row "locate other installation locations" u have to locate pro/m, example on my computer :C:\PTC\mechWildfire 2.0. U continue click next to finish. Now u can run pro/e with application mechanica.


I hope it can help u.

 

[mit_joel]

huynhthanhlich,


You're the man. Thanks a lot. All fixed now.


-Joel