Angre
Marine/Ocean
- Dec 18, 2013
- 50
Iam a FEMAP newbie.
When I want to create a point, I go
Geometry , point , then a dialogue box titled "Locate-Enter coordinates or select with cursor"
This dialogue box has Method toolbar , which on clicking shows a lot of choices like Locate , Locate in workplane .. Onto curve Along Curve etc.
My query is where can I find the definitions on these choices.I have looked at commands manual and can t find one.
Please help.
Rgds
Angre
When I want to create a point, I go
Geometry , point , then a dialogue box titled "Locate-Enter coordinates or select with cursor"
This dialogue box has Method toolbar , which on clicking shows a lot of choices like Locate , Locate in workplane .. Onto curve Along Curve etc.
My query is where can I find the definitions on these choices.I have looked at commands manual and can t find one.
Please help.
Rgds
Angre
