Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

MC model concept

Status
Not open for further replies.

Vxxxxx

Mechanical
Joined
Jun 5, 2020
Messages
91
Location
MY
Hi, just one quick question. Since I only provide cohesion(c) and dilation angle(ϕ) to ABAQUS, does that mean ABAQUS monitor the hydrostatic stress during the simulation process and determine the yield stress?
Thank you.

23_iacouo.png
 
Actually, for Mohr-Coulomb model you have to specify:
- friction angle
- dilation angle
- cohesion yield stress
- abs plastic strain

The last two parameters are for Mohr-Coulomb hardening.
 
Thanks FEA way, I am aware of that but could you clarify my statement about hydrostatic stress?
For example, we do not have to provide compressive stress in this diagram, so does that mean that ABAQUS monitor the compressive stress on x-axis and decide the yield stress on the y-axis? Thanks.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top