Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mazak Cut Conditions

Status
Not open for further replies.
ksbarlow67

ksbarlow67

Industrial
Joined
Nov 7, 2019
Messages
1
Location
US
Hey everyone, New here to this forum.
Currently I am trying to cut some .012 304 Stainless Steel using a Mazak Hyper Turbo x 510 and i was wondering if anyone had cut conditions for that thin of material for the slow cut condition. Any help is greatly appreciated.
 
Status
Not open for further replies.

Similar threads

B
  • Question Question
how to laser cut a cylinder
Replies
0
Views
5K
Bluces
B
Garrett Green
  • Locked
  • Question Question
Mazak Laser having trouble cutting 1/2" Material
Replies
0
Views
1K
Garrett Green
Garrett Green
brianTC
  • Locked
  • Question Question
LC 3015 F1 NT 4kW Cutting Conditions
Replies
0
Views
222
brianTC
brianTC
B
  • Question Question
Will there be problems with the cutting section if the laser cutting speed is too fast or too slow?
Replies
3
Views
444
IRstuff
IRstuff
lasertech716
  • Locked
  • Question Question
Trying to cut 7 gauge steel hrs
Replies
3
Views
501
IRstuff
IRstuff

Part and Inventory Search

Sponsor

Back
Top