Mattew scott
Electrical
Can anyone advise me? I'm trying to simulate the Bit Error rate of vehicle-to-vehicle communications using the IEEE 802.11p standard at it's different MCS's in an AWGN, Rician and Rayleigh channels, as well as according to the nodes mobility. When running a monte carlo simulation with just the AWGN channel, the results appear as expected. However, when adding in a Rician or a Rayleigh channel, the results seem incorrect, as shown below:
What i expect the results to look like is shown below:
[URL unfurl="true"]https://res.cloudinary.com/engineering-com/raw/upload/v1697300057/tips/unexpected_results_awjzji.docx[/url][URL unfurl="true"]https://res.cloudinary.com/engineering-com/raw/upload/v1697300077/tips/Expected_results_uoebhl.docx[/url]
Any assistance and advise would be greatly appreciated
What i expect the results to look like is shown below:
[URL unfurl="true"]https://res.cloudinary.com/engineering-com/raw/upload/v1697300057/tips/unexpected_results_awjzji.docx[/url][URL unfurl="true"]https://res.cloudinary.com/engineering-com/raw/upload/v1697300077/tips/Expected_results_uoebhl.docx[/url]
Any assistance and advise would be greatly appreciated