Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

material help needed

Status
Not open for further replies.

lusc10

New member
Joined
Feb 15, 2011
Messages
1
Location
US
I am in need of a .125 x 4' x 16' sheet of 2024 t3 for a restoration project. Any ideas where I could buy a sheet this long or a company that uses longer then standard sheets. Any ideas would be very helpful.

Randy
 
I think you are going to have to go to Reynolds or Kaiser and special order this.
Most jobbers are going to carry 12"-0" stock as standard.
You may find a supply house in the Pacific north west that supplies Boeing, or a supplier in Atlanta who supplies Lockheed

Here is a link to Kaiser.
Good luck.
B.E.
 
lusc10...

bare or clad?

Regardless... have You tried contacting ["and asking for help"] any of the following suppliers?

[catalog shows 0.125 X 4' X 12' @$600 unk: bare or clad????]



Regards, Wil Taylor

Trust - But Verify!

We believe to be true what we prefer to be true.

For those who believe, no proof is required; for those who cannot believe, no proof is possible.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top