material help needed

[lusc10]

I am in need of a .125 x 4' x 16' sheet of 2024 t3 for a restoration project. Any ideas where I could buy a sheet this long or a company that uses longer then standard sheets. Any ideas would be very helpful.

Randy

 

[berkshire]

I think you are going to have to go to Reynolds or Kaiser and special order this.
Most jobbers are going to carry 12"-0" stock as standard.
You may find a supply house in the Pacific north west that supplies Boeing, or a supplier in Atlanta who supplies Lockheed

Here is a link to Kaiser.
Good luck.

http://www.kaiseraluminum.com/about-us

B.E.

 

[WKTaylor]

lusc10...

bare or clad?

Regardless... have You tried contacting ["and asking for help"] any of the following suppliers?

http://www.twmetals.com/

http://www.tmxaerospace.com/tmxa/index.htm

http://www.aerospacemetals.com/

http://www.metals-r-us.com/

http://www.aircraftspruce.com/cathome.php

http://www.wicksaircraft.com/

[catalog shows 0.125 X 4' X 12' @$600 unk: bare or clad????]

http://www.wagaero.com/

Regards, Wil Taylor

Trust - But Verify!

We believe to be true what we prefer to be true.

For those who believe, no proof is required; for those who cannot believe, no proof is possible.