Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Material for Naphtha with 100 ppmw H2S

Status
Not open for further replies.
Novak11

Novak11

Petroleum
Joined
Jun 16, 2014
Messages
6
Location
CZ
Do you think it is OK to use Carbon steel with just 3 mm CA for Heat Exchanger for naphtha with content of 100 ppmw of H2S?
Thanks
 
Sort by date Sort by votes
It is naphtha stabilizer and temp. is 165 degC. In the meantime I checked couple of similar applications and found that all materials are really CS+3mm CA.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

dandy408
  • Question Question
Strongest material heat treated or non-heat treated
Replies
1
Views
6K
EdStainless
EdStainless
ritsa p
  • Locked
  • Question Question
Positive Material Identification (PMI)
Replies
9
Views
4K
mrfailure
mrfailure
FrancoisY
  • Locked
  • Question Question
Material 12L14 Steel
Replies
3
Views
3K
dtimberlake
D
metboss
  • Locked
  • Question Question
Material selection for H2S and CO2 application
Replies
5
Views
820
metboss
metboss
novateague
  • Locked
  • Question Question
Optimal Splined Shaft Material for Low Cycle Fatigue
2
Replies
33
Views
2K
novateague
novateague

Part and Inventory Search

Sponsor

Back
Top