mauzyb
Mechanical
- Jul 10, 2007
- 18
I have some images of company logos that I need to make into a DXF to burn on laser. I have been importing a JPEG then just clicking around it with a spline. Is there a better program to run the images thru first? has anyone used a digital pen for tracing?
This is not something my company does professionally or for profit, so I wont buy expensive software for the operation. These tend to be logos and are unique fonts so just extruding text will not look right, and of course I have to add points to keep letter centers from falling out.
Any help or direction on who else to ask would be greatly appreciated.
This is not something my company does professionally or for profit, so I wont buy expensive software for the operation. These tend to be logos and are unique fonts so just extruding text will not look right, and of course I have to add points to keep letter centers from falling out.
Any help or direction on who else to ask would be greatly appreciated.
