Igor62
Structural
- Jun 28, 2015
- 2
Hi,
I would like to know what kind of rules design stantards gives to define overlapping length for loop connection.
I have seen different ways
a) loops are not overlapping, there is just one bar inside loops
b) loops should overlap at least 10*diameter / 20*diameter
Best regards
Igor
I would like to know what kind of rules design stantards gives to define overlapping length for loop connection.
I have seen different ways
a) loops are not overlapping, there is just one bar inside loops
b) loops should overlap at least 10*diameter / 20*diameter
Best regards
Igor
