Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Lofting and flattening
- Thread starter gus58
- Start date
Dear GUS,
In normal case do you want use a SHEET_METAL-LOFT command do create this loft. This command is in sheet metal pull down.
It's rare do you flatened a solid loft command, but when do you recognize a solid select a EDGE from the loft.
REgards
FerSW![[bigglasses]](/data/assets/smilies/bigglasses.gif "[bigglasses] [bigglasses]")
In normal case do you want use a SHEET_METAL-LOFT command do create this loft. This command is in sheet metal pull down.
It's rare do you flatened a solid loft command, but when do you recognize a solid select a EDGE from the loft.
REgards
FerSW
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question
