Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Lofting and flattening

Status
Not open for further replies.

gus58

Structural
Joined
May 4, 2003
Messages
1
Location
AU
Does anyone know how to flatten a loft? I'm trying to design a boat and have my bow loft modelled but cannot flatten it. Any help appreciated
Gus
 
Dear GUS,
In normal case do you want use a SHEET_METAL-LOFT command do create this loft. This command is in sheet metal pull down.
It's rare do you flatened a solid loft command, but when do you recognize a solid select a EDGE from the loft.

REgards


FerSW [bigglasses]
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top