Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When location and orientation tolerances are provided for same feature, location tolerance will not control the orientation.
Now without considering the location, how this feature can be parallel within 0.5 wrt datum A?
Burunduk said:Once you are sure you fully understand this combination of geometrical controls, the next thing you might want to look into is composite profile tolerance for a single feature.
greenimi said:I am thinking that the committee's intent was to reserve composite for multiple features not for a single feature.
greenimi said:May I ask a question: I know has been discussed before (maybe for 1994 / 2009 version of the ASME Y14.5 standard) but is it recommended/ allowed to use composite tolerance for a single feature as suggested by Burunduk?
Or maybe it is allowed but not a good practice?
What do you think? Pros/ cons of such of practice ?
I am thinking that the committee's intent was to reserve composite for multiple features not for a single feature.