Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

load through table?

Status
Not open for further replies.
rahulbarve

rahulbarve

Structural
Joined
Aug 3, 2008
Messages
20
Location
SG
hi,
i have to apply load on beam. the load varies along the length, i have this load vs x in table format. how can i apply it on the beam in STAAD.Pro
 
Sort by date Sort by votes
Check the manual section 5.32.2 Member Load Specification for the LIN or TRAP options
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

PKOM
  • Locked
  • Question Question
Wind load for attach canopy
Replies
1
Views
2K
gongaga
gongaga
justhumm
  • Locked
  • Question Question
STAAD user table (UPT) error?
Replies
3
Views
3K
dozer
dozer
justhumm
  • Locked
  • Question Question
"Cannot Create Load Generation Command" error.
Replies
1
Views
2K
CarlosAguera
CarlosAguera
dccd
  • Locked
  • Question Question
Moving load included in load combination
Replies
2
Views
674
netsonicyxf
netsonicyxf
teach_me
  • Locked
  • Question Question
How to transfer roof truss loads to steel columns if the truss analysis is localized
Replies
2
Views
1K
dozer
dozer

Part and Inventory Search

Sponsor

Back
Top