Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

lisp and mechanical desktop

Status
Not open for further replies.
alicia

alicia

Mechanical
Joined
May 12, 2001
Messages
2
Location
CA
Does anybody has a lisp program or a program that will draw
a tube from one fitting to another by clicking on the center of one "elbow" to another elbow" and making the tube with the right diameter and extruded to the distance found while performing the command dist?
please!!!
thanks
ALicia
 
Status
Not open for further replies.

Similar threads

skimmerman
  • Locked
  • Question Question
Opening drawing in Mechanical Desktop
Replies
1
Views
765
5177
5177
yiannistamv
  • Locked
  • Question Question
autodesk mechanical dimensioning variables
Replies
0
Views
728
yiannistamv
yiannistamv
Davercn
  • Locked
  • Question Question
Installing Mechanical Desktop 4.0 on Windows XP
Replies
2
Views
313
scastillo
scastillo
CadArtist
  • Locked
  • Question Question
Mechanical Desktop 6 vs. 2006/2007
Replies
0
Views
326
CadArtist
CadArtist
Mengi
  • Locked
  • Question Question
Problems with Mechanical desktop
Replies
1
Views
260
dpzinn478
dpzinn478

Part and Inventory Search

Sponsor

Back
Top