I am attempting to desing a lifting trunnion made of 10" sch. 80 pipe welded onto a thin wall steel stack. The lift will be approx 100 kips. I am looking for a good design routine to aid in the calculations. I am considering using WRC 297 as a design basis, but I was wondering if any else has a better idea. Thanks in advace for your help.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
lifting trunnion
- Thread starter stack1
- Start date
Dennis R Moss "Pressure Vessel Design Handbook" Gulf Publishing is very practical. He refers to I Magnusson "Design of Davits", Fluor Engineers Inc, Irvine, California, and R J Roard "Formulas for Stress and Strain".
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question