Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Lengthen datum axis

Status
Not open for further replies.

TomFlyer

Aerospace
Joined
Feb 26, 2005
Messages
7
Location
US
Using NX4, I created an additional datum axis on a part drawing a certain distance from the original Z-axis. The resulting arrow/line is very short, making it difficult to select for arrays and such. Is there a function in NX4 that allows one to lengthen the axis line as is done with planes for better visibility?

Tom Sidloski
Unison Engine Components
 
One workaround until you get to NX5 is to create a cylinder (either a primitive or extrude one) and associate a datum axis to the axis of the cylinder. Now if you lengthen the cylinder, the datum axis will grow longer to match. You can blank the cylinder or put it on an unused layer if you don't want to see it.
 
Try going to "Insert", "Datums" then "Resize Fixed Datums" and see if that helps.

Al
 
To John Baker: I was afeared of that, but the 2 following replies helped a bit. Thanks for your reply.
To cowski: I was ready to create a cylinder as you suggested when the next reply seemed even more viable. I see no reason why that wouldn't work. Thanks for your reply.
To Agriego: That did work, and I thank you.

We have NX5 sitting here gathering dust until our IT department gets off their duffs and installs the newfangled license on our server. NX6 will probably be out before they get to that.
Once again, thanks to all.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top