Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Leader termination point

Status
Not open for further replies.

rmorgan890

Mechanical
Joined
Sep 23, 2011
Messages
70
Location
US
Using NX9

Sometimes when adding a Note, Finish Symbol, etc to a drawing, NX will allow me to select anywhere on a Dimension Extension Line for my leader termination point (my preference). Other times, when I try to select a Dimension Extension Line for my leader termination point, it snaps to the intersection of the Dimension Extension Line and the Dimension Line. Anybody know why??

Thank you!!
 
It could be what is selectable based on your point choices

junk11_b4nwxz.png


Jerry J.
UGV5-NX11
 
Made no difference in this case. Thanks.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top