Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Layout Transition

Thread starter KentCaudill
Start date Mar 1, 2004

Status: Not open for further replies.

Mar 1, 2004

KentCaudill

Industrial

Where can I find a simple spreadsheet or other software solution to calculate the surface area and flat pattern for a square to round transition? Something simple, not costing a lot of money (mostly free), to be used for estimating the weight of the plate and the blank size of the plate used to make the transition. Thanks in advance for your suggestions. Kent.

Thanks for your help, Kent.