I am finding a HUGE lag in the 2005 mechanical layer manager. It'll take forever to actually load the layers, and even then it doesn't actually show the layer states (I can move the mouse over the thaw or freeze and select it, but I can't actually see the icon to know what it curently is) any one know of a remedy? Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Layer Window in Mechaical 2005
- Thread starter TDevil
- Start date
FYI, the layers are not actually created until a Mechanical object is created. The layer dialog lets you see the current layer configuration that is in place. If you were to create a bolt or begin drawing an object's contour, the layer states would begin to show up based on the object created. I hope I am making sense.
"Everybody is ignorant, only on different subjects." — Will Rogers
"Everybody is ignorant, only on different subjects." — Will Rogers
- Status
Similar threads
- Locked
- Question