I would like to have a strip of Ti64 (cross section .7 x 4 mm) welded to a block 3 mm thick. I would like to run a seam (.2 mm deep) down the 4 mm length (from A to B in the attached image). My question is at what point along the thickness (t) of the part will the temp drop down to below 100C? 2x the spot size?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Laser welding-- surface temp and spot size in Ti64
- Thread starter kkeenn
- Start date
Similar threads
