Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
laser cut
- Thread starter HectorMEC
- Start date
Don't you think that a little more description of your problem besides, "having trouble," might elicit more and better responses?
TTFN
faq731-376
Need help writing a question or understanding a reply? forum1529
Of course I can. I can do anything. I can do absolutely anything. I'm an expert!
TTFN
faq731-376
Need help writing a question or understanding a reply? forum1529
Of course I can. I can do anything. I can do absolutely anything. I'm an expert!
Generically speaking, our operators sometimes have issues:
1. material has rust. they usually will palm sand rust off for better results.
2. oxygen pressure too high (or low), especially in tight geometries, causing blowouts.
3. then you have the usual suspects like with everything else like focus, feedrate etc.
What exactly is your problem? Blow outs, hard dross, edge quality?
"I am stuck on Band-Aid brand, 'cause they are stuck on me"
1. material has rust. they usually will palm sand rust off for better results.
2. oxygen pressure too high (or low), especially in tight geometries, causing blowouts.
3. then you have the usual suspects like with everything else like focus, feedrate etc.
What exactly is your problem? Blow outs, hard dross, edge quality?
"I am stuck on Band-Aid brand, 'cause they are stuck on me"
- Status
Similar threads
- Question
