Landing gear assembly

[jbelle7435]

I have been given a project to create a landing gear. I have created all the parts and made the assembly. My problem is how to place the pins at these three given ground points so when I do a dynamic analysis those three points will not move with the rest of the object. The sheet given just has three points called PNT0.


PNT0-- (-9.6)----


PNT0 | (29.379)


| |


|(7.614)


------------------(-27.145)-------------------------------PN T0





best way to describe it...Anyone can help thanks!

 

[cristelino]

you have an e mail adres ?

a have something but a i think must modify

could handle with if you have the solid models?



I can send- you some



Cheers



Cristel

 

[jbelle7435]

I figured out how to make datum points. now when I assembly I have major trouble aligning my parts to these points.





I made a seperate part of 3 datum points. Went into assembly mode and loaded points file. Now I load a part to align with the points and I can not figure out how to easily.