Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

K-Factor in bend line notes

Thread starter JohnTM
Start date Nov 1, 2010

Status: Not open for further replies.

Nov 1, 2010

JohnTM

Mechanical

The default on drawings for bend line notes is "<bend-direction> <bend-angle> <bend-radius>" ,and that is of course controlled by the contents of a text file.

Can I add something to this file, so that the K-Factor of each bend always shows up at the end of the note? If yes, what do I add?

Thanks