Mohamed Gaballah
Mechanical
how to decide wear or pettings on shaft surface of journal bearing
to what range they are accepted or shaft needs replacement
to what range they are accepted or shaft needs replacement
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Journal Bearing shaft wear or peittings
- Thread starter Mohamed Gaballah
- Start date
- Status
What did the equipment manufacturer have to say in the O&M manual, or on their tech line?
Hydrostatic or hydrodynamic ?
Heavy duty truck or automotive ?
The attached pdf has the "good stuff" from page 177.
Note roundness, size, taper, surface finish, and even the direction of journal polishing can profoundly affect hydrodynamic bearing life.
All is good, until it is not.
Hydrostatic or hydrodynamic ?
Heavy duty truck or automotive ?
The attached pdf has the "good stuff" from page 177.
Note roundness, size, taper, surface finish, and even the direction of journal polishing can profoundly affect hydrodynamic bearing life.
All is good, until it is not.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question