Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Joint Axis Settings Problem

  • Thread starter Thread starter BrankoD
  • Start date Start date
B

BrankoD

Guest
In WF 3.0 when I use Mechanism Design and create pin connection, in Joint Axis Settings Dialog before I choose Component Zero Reference and Assembly Zero Reference, sometimes I have Make Zero option, sometimes I don`t. I have read explanation that this option is only for legacy mechanisms. This option was very useful for me. Is there any way to have this option active all the time? Or is there any idea how to simplify work without her?
 
No comments?
smiley19.gif
 
When defining a Joint Axis spring, the unstretched location is assumed to be at the defined joint axis zero location.This is a good example why I need Make Zero option, correct me if I`m wrong.
 
You must log in or register to reply here.

Similar threads

Bobfromoh
  • Locked
  • Question Question
Bolting in Axisymmetric model
Replies
0
Views
731
Bobfromoh
Bobfromoh
hkenyon
  • Locked
  • Question Question
Creo 2 simulate lite problems. "MyAnalysis" has already been defined.
Replies
1
Views
813
dgallup
dgallup
J
Drawing Module (Axis)
Replies
0
Views
2K
jdsmustang
J
W
Problem with assembly weight
Replies
1
Views
3K
Coosa
C
Angothoron
  • Locked
  • Question Question
Assembly Problems Non-Linear Analysis
Replies
1
Views
443
shaun8567
shaun8567

Part and Inventory Search

Sponsor

Back
Top