Wchen
Computer
- May 13, 2012
- 2
Hello everyone. I have small personal project that I would like some help on. I need to join two piece of glass filled nylon with not a lot of surface area to work with. The joint needs to withstand 200+ degrees Fahrenheit as well as some impulse energy. My primary question is should I use adhesive or plastic welding to join the two pieces. I have some scarp that I can use for the plastic welding by using a small soldering iron-like hand tool but I would like to know if Devcon Plastic Welder adhesive might give a similar result. Thanks for reading.