Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ISO #40 TAPERED SHANK COLLET CHUCKS

Status
Not open for further replies.
4DUKH402

4DUKH402

Mechanical
Joined
Apr 5, 2003
Messages
1
Location
GB
WHAT METHODS CAN BE USED TO PRODUCE #40 TAPERED SHANK COLLET CHUCKS USING A CENTRE LATHE
 
Sort by date Sort by votes
On a engine Lathe, you can swing the conpond arouns and do a a short taper, or if you are lucky enough to have alathe that has a taper attachment, and for skinny tapers you can offset the tail stock
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

ArturKwoka
  • Locked
  • Question Question
Counterbore hole tolerances for iso 4762 screws
Replies
9
Views
1K
drawoh
drawoh
kyleShropshire
  • Locked
  • Question Question
Design of tapered shaft friction coupling
2
Replies
29
Views
2K
geesaman.d
geesaman.d
George9494
  • Locked
  • Question Question
ISO drafting standard - Thread annotation with depth
Replies
5
Views
2K
MintJulep
M
engineeringspread
  • Locked
  • Question Question
Aluminium Extrusion - Tapered Section
Replies
7
Views
746
engineeringspread
engineeringspread
PRESSEDSTEEL
  • Locked
  • Question Question
Tapered Shafts
Replies
7
Views
1K
GregLocock
GregLocock

Part and Inventory Search

Sponsor

Back
Top