Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Is This Correct? Attached is simulation.

Thread starter SudorracMechEng
Start date Jan 16, 2012

Status: Not open for further replies.

Jan 16, 2012

SudorracMechEng

Mechanical

Attached is a jackstand assembly, i tried my best to model the situation as close to real life as possible. I need to make sure the pin is safe for use - I just want to know if the actual boundary conditions, restraints and loads are correct..

I can alter the pin diameter at a later date.

Thankyou!