Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Is This Correct? Attached is simulation.

Status
Not open for further replies.
SudorracMechEng

SudorracMechEng

Mechanical
Joined
Jan 12, 2012
Messages
12
Location
AU
Attached is a jackstand assembly, i tried my best to model the situation as close to real life as possible. I need to make sure the pin is safe for use - I just want to know if the actual boundary conditions, restraints and loads are correct..

I can alter the pin diameter at a later date.

Thankyou!
 
Status
Not open for further replies.

Similar threads

A
  • Locked
  • Question Question
Flow simulation evaporative cooling
Replies
0
Views
908
arimaulanar
A
IdanPV
  • Locked
  • Question Question
Apply Moments in Solidworks Simulation
Replies
2
Views
2K
IdanPV
IdanPV
Joel_Lapointe
  • Locked
  • Question Question
Cylindrical coordinate system shear stresses for SolidWorks Simulation?
Replies
0
Views
1K
Joel_Lapointe
Joel_Lapointe
lpresciuttini
  • Locked
  • Question Question
Pressure Vessel Linearization (Simulation): Invalid points
Replies
1
Views
1K
IdanPV
IdanPV
Joel_Lapointe
  • Locked
  • Question Question
Impose mesh coordinates multiple different simulations (SolidWorks Simulation)
Replies
2
Views
1K
Joel_Lapointe
Joel_Lapointe

Part and Inventory Search

Sponsor

Back
Top