Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Interpretation of AMS 2681B para 4.3.2

Status
Not open for further replies.

kevlar49

Materials
Joined
Jun 1, 2006
Messages
287
Location
US
AMS 2681 B para 4.3.2 states that "For Procedure Certification: Not less than three welds for proeceudre certification representative of each joint in the part or assebly. When test welds are made on actual hardware, one part may be welded for procedure certification". Do you interpret this to mean that if we use a test joint that is only representative of the actual joint that we are required to have at least three welds performed, however if we use an actual part we only need one weld performed?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top