nauticalmike
Marine/Ocean
I'm sure that this is an easy question for most, but I am wondering how an internal spline is cut. For that matter, how is an external spline cut.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Internal splines
- Thread starter nauticalmike
- Start date
- Status
GregLocock
Automotive
Internal splines are often broached. They could be cut in a shaping machine at a pinch. The world's your lobster for external splines- they could be rolled, cut in a shaper machine, milled, or I suppose even carved out with a chisel. Basically any way you can make a gear.
Cheers
Greg Locock
Cheers
Greg Locock
- Status
Similar threads
- Locked
- Locked
- Question
- Locked
- Question
- Locked
- Question