Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Interface Relays for resolver signals

Status
Not open for further replies.

greta

Electrical
Nov 13, 2002
14
GB
Everyone,

I am in need of an interface relay compatible with resolver signals. My ultimate goal is to drive six dry change-over contacts that will allow me to switch the resolver from one servodrive to another (without building a
circuit board!).

HELP!

Thanks,
Greta
 
Replies continue below

Recommended for you

Obviously the most durable method would be to use a pair of HEX transmission gates (or bi-lateral switches or analog switches, whichever you wish to call them). If you only wish to drive six reed relays why can you not use any ordinary relay (or a simple transistor or Op-Amp driver)?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top