I am trying to research a modele in Abaqus by thermal and mechanical analysis. The module has several contact points. Firstly, I thought about defining contact points through „Tie Contact“. The program ran quite well. After I got results, I wanted to replace „Tie Contact“ with „Interaction Contact“. Unfortunately after a few minutes the program breaks by an error message "Displacement increment for contact is too big". I have already tried to change the geometry at the contact points and vary Increment Size without any success (I would be very happy for some help). Tank you in advance
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Interaction Contact in Abaqus
- Thread starter M-17
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
