Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Install Pro Engineer wildfire 3.0

  • Thread starter Thread starter scotty55
  • Start date Start date
S

scotty55

Guest
I am trying to install the student version of Pro Engineer Wildfire 3.0.


After the install i get the warning Invalid Host then the program shutsdown.


I noticed at the start of the install the Host Id was blank.When i check ipconfig/all opposite physical address is also blank.


I assume its something to do with the Ethernet network connection setup ? Do i need to set up a client or service or protocol network ? I don't know anything about networks...


Can anyone help ?


Thanks,Scott
 
You must log in or register to reply here.

Similar threads

Designer_D
  • Locked
  • Helpful tip Helpful tip
Original Pro/Engineer Blue Background Color Values (thread554-165973)
Replies
0
Views
2K
Designer_D
Designer_D
pmbov
  • Locked
  • Question Question
Creo 10 Pro/program Problems
Replies
7
Views
2K
3DDave
3DDave
kaengo
  • Locked
  • Question Question
Problems with Creo 3.0 Graphics
Replies
0
Views
262
kaengo
kaengo
T
Searching for Creo 3.0 License
Replies
0
Views
4K
tito1983
T
J
Pro-E Wildfire 4.0 Programming assistance needed !!
Replies
0
Views
3K
Joe Pie
J

Part and Inventory Search

Sponsor

Back
Top