Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Input field for tolerance/clearance

Thread starter ebrehe
Start date Nov 20, 2013

Status: Not open for further replies.

Nov 20, 2013

ebrehe

Mechanical

Hi all,

I have basic shaft/hole problem with contact. I have already solved it without clearance. Now I want to see the effects of ISO clearances like H7/e7 or H7/d7.

I know I can modify my geometry with cut etc. to achieve required clearance. But I wonder if there is an input field that I can easily enter the input like 0.356 mm.

Thanks!