Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ingresol Rand Air dryer problem

Status
Not open for further replies.

Saikot Mahmud

Mechanical
Dec 24, 2019
6
I have air dryer of Ingersoll Rand. It was running smoothly . But there rises problem of shut down and a signal shown on E5A when dryer goes to shut down. What might be the possible causes and what measures should be taken?
The discharge air dryer refrigerant compressor was about 13 bar and suction pressure was to 5 bar .
At normal running condition the suction pressure was 15 bar and discharge pressure was 5 bar
 
Replies continue below

Recommended for you

the suction pressure was 15 bar and suction pressure was 5 bar

??
 
Sorry information will be
Suction pressure 13 bar
Discharge pressure 5 bar
 
I don't think this issue rises to the level of what was imagined when this forum was created, nor when comparing it to the incidents which have been highlighted here.

John R. Baker, P.E. (ret)
EX-Product 'Evangelist'
Irvine, CA
Siemens PLM:
UG/NX Museum:

The secret of life is not finding someone to live with
It's finding someone you can't live without
 
Suction pressure 13 bar
Discharge pressure 5 bar


Suction higher than discharge for compressor.....?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor