Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
induction heating coil design 2
- Thread starter alschott
- Start date
-
1
- #2
-
1
- #3
It is a good article.
We go to Ameritherm for this.
E. J. (Chip) LASKOWSKI
National Sales Manager
39 Main Street
Scottsville, New York 14546
Tel: 585-889-0246
Fax: 585-889-4030
chiplaskowski@ameritherm.com
Thomas J. Walz
Carbide Processors, Inc.
We go to Ameritherm for this.
E. J. (Chip) LASKOWSKI
National Sales Manager
39 Main Street
Scottsville, New York 14546
Tel: 585-889-0246
Fax: 585-889-4030
chiplaskowski@ameritherm.com
Thomas J. Walz
Carbide Processors, Inc.
- Thread starter
- #4
Thank you for the pointer to the magazine article, I'll check it out.
I looked at ameritherm's website, we are in the initial stages of testing the process. We have a decent machine now, just need to be able to process more than one at a time to get the cost down.
I looked at ameritherm's website, we are in the initial stages of testing the process. We have a decent machine now, just need to be able to process more than one at a time to get the cost down.
Amerithem is closed this week.
We do a lot of unusual carbide brazing. Last year we bought a couple of the little 1 kw Hot Shots systems from Ameritherm largely because of their tech support. (I have been doing brazing consulting for over twenty years and have seen a lot of folks with induction systems and no tech support.) Their lab is very good at designing solutions based on the parts we send them. The closest thing to a problem we have had is when we wanted to buy a couple new shapes for R&D. The salesperson didn’t want to sell them to until he was sure they would work. We just wanted to try a couple ideas and figured $1,000 for two coils wasn’t a whole lot. We contacted Girish Dahake (neat guy) directly and he had them made for us. They didn’t work very well in production but they did teach us a lot.
tom
Thomas J. Walz
Carbide Processors, Inc.
We do a lot of unusual carbide brazing. Last year we bought a couple of the little 1 kw Hot Shots systems from Ameritherm largely because of their tech support. (I have been doing brazing consulting for over twenty years and have seen a lot of folks with induction systems and no tech support.) Their lab is very good at designing solutions based on the parts we send them. The closest thing to a problem we have had is when we wanted to buy a couple new shapes for R&D. The salesperson didn’t want to sell them to until he was sure they would work. We just wanted to try a couple ideas and figured $1,000 for two coils wasn’t a whole lot. We contacted Girish Dahake (neat guy) directly and he had them made for us. They didn’t work very well in production but they did teach us a lot.
tom
Thomas J. Walz
Carbide Processors, Inc.
- Status
Similar threads
