golfdogdave
Aerospace
- May 5, 2014
- 4
If a view is taken at 45 degrees can it be shown horizontal on the drawing
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
In NX 8.5 can a view or section be rotated after it is placed?
- Thread starter golfdogdave
- Start date
- Status
patelmimnesh
Mechanical
- Jun 19, 2013
- 3
yes..
but you place/upload any image or part,it's more better to understand here.
Mimnesh,
but you place/upload any image or part,it's more better to understand here.
Mimnesh,
KhimaniMohiki
Automotive
Edit > Style > General > Angle
This will rotate the view to whatever angle you want.
Khimani Mohiki
Design Engineer - Aston Martin
NX8.5
This will rotate the view to whatever angle you want.
Khimani Mohiki
Design Engineer - Aston Martin
NX8.5
- Status
Similar threads
- Locked
- Question