Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Impse set of Displacement

Status
Not open for further replies.
mhtehrani

mhtehrani

Structural
Joined
Aug 21, 2012
Messages
2
Hi

I want to impose a set of Displacement in C.M. in all levels to get results from Nonlinear Static Analysis.
I have a 10 story mass eccentric model taht I manually defined nodes and assigned masses to them.

Please HELP me
every comments would be appreciate
 
Status
Not open for further replies.

Similar threads

P
  • Question Question
Target displacement
Replies
0
Views
1K
PiaKoerz
P
N
  • Question Question
SAP 2000 - Center of Mass and Center of Rigidity
Replies
0
Views
6K
Neeka
N
J
  • Locked
  • Question Question
Question about the definition of transfer beams in a pile cap for a pedestrian bridge foundation
Replies
0
Views
2K
jcarlosamao
J
hadsyogs
  • Locked
  • Question Question
Error 9 on SAP2000 "subscript out of range" ,help
Replies
3
Views
2K
CSIESPL INDIA
CSIESPL INDIA
juandavidguzman
  • Locked
  • Question Question
SAP2000 Nonlinear Analysis Setup for Steel Design: Notial loads
Replies
2
Views
2K
STpipe
STpipe

Part and Inventory Search

Sponsor

Back
Top