Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Importing loads from Mechanism

Status
Not open for further replies.

Paolodm

Mechanical
Joined
Oct 7, 2008
Messages
3
Location
IT
Hi to all,

When I import loads from Mechanism, the software considers all loads as TLAP (total load at point). Have I only to choose surfaces associated with loads? If I change TLAP into TL can i make a mistake?

Thank you.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top