Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
I need a MOM variable for selecting which plane is in use
- Thread starter Craigb350
- Start date
What version of NX and Post Builder are you using
What type of machine is this? Mill, Lathe?
If it is a mill look at the custom commands there is one there for plane selection. You and also turn on the review tool and that should list the mom variables.
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6, NX7.5 & NX8.5
Vericut7.2.3
What type of machine is this? Mill, Lathe?
If it is a mill look at the custom commands there is one there for plane selection. You and also turn on the review tool and that should list the mom variables.
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6, NX7.5 & NX8.5
Vericut7.2.3
- Status
