Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

i hate MULTIPRO

  • Thread starter Thread starter -
  • Start date Start date
Status
Not open for further replies.

Guest
My problem is:
I am doing a macro and i use MULTIPRO now to the entries, but it is slow, i dont know why. Is there other option with the menus? I like changing menus' aspect but with this command it is not possible. Will be neccesary programming the GUI?

Thank you,
 
Status
Not open for further replies.

Similar threads

W
  • Question Question
Trying to couple a transient thermal and structural simulation but I get zero deformation and stress
Replies
0
Views
2K
weldtest12
W
andradesilva
  • Locked
  • Question Question
I am not able to see fracture of the specimen in explicit dynamics in ANSYS Workbench 2023 R1
Replies
0
Views
382
andradesilva
andradesilva
student2022
  • Locked
  • Question Question
Printing index (%i%) in *do loop in Workbech
Replies
1
Views
377
jkupka84
jkupka84
andradesilva
  • Locked
  • Question Question
problem: How can I configure Autodesk Inventor Associative Interface?
Replies
1
Views
318
jkupka84
jkupka84
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H

Part and Inventory Search

Sponsor

Back
Top