Hyperlinks in drawing notes

[tclark]

We wish to have hyperlinks, in notes on drawings, to standard specification files. SW allows an entire note to be hyperlinked. We want to be able to have just a selected portion of the note (e.g., the file name of a specification) active to access the targeted specification. In fact, it is desirable to be able to link to more than one file in a single note.

Can anyone suggest how this might be done?

TIA

 

[SBaugh]

Looks like wanting more than just a hyperlink in a note is going to be a Enhancement request. You could add a word document but you would have to double click to get to the hyperlink.

Again if you want more than one link in a single note you will need to place an Ehancement Request in.

Unless someone has found a different way?

Best Regards, Scott Baugh, CSWP
3DVision Technologies
credence69@REMOVEhotmail.com

http://www.3dvisiontech.com

http://www.3dmca.com

*When in doubt always check the help*

 

[linqur]

..and have you tried to remove the hyperlink from note?
You have to copy the content of note an recreate it in order to get rid of hyperlink.