Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hydraulic Piping Field Installation Question

Status
Not open for further replies.
BoiseENG

BoiseENG

Mechanical
Dec 1, 2009
6
I'm trying to write a specification for the field installation of 5000psi hydraulic piping. I need to know if there are any standards out there for finishing, welding, pickeling, etc. for this operating pressure. 6000lb socket weld fittings and butt welds for pipe will be used for the installation.

Thanks for the help.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

W1987
  • Question
Question about weld fillet reinforcement in PJP or CJP joints
Replies
2
Views
2K
SJones
SJones
danggg
  • Locked
  • Question
AWS D17.1 WELDER CERT. QUESTION
Replies
2
Views
367
GC_Hopi
GC_Hopi
OZWelder
  • Locked
  • Question
PQR D1.1 Diameter question
Replies
1
Views
433
pipewelder1999
pipewelder1999
deepsteelblue
  • Locked
  • Question
Manhour Calculation for Welding CS Piping
Replies
1
Views
274
kingnero
kingnero
swearingen
  • Locked
  • Question
Question on Grinding a Weld Type
Replies
1
Views
348
DVWE
DVWE

Part and Inventory Search

Sponsor

Back
Top Bottom