Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

HR Steel Thickness Tolerance for .250 Thick

Status
Not open for further replies.

vendo

Mechanical
Nov 13, 2007
2
I can not find the thickness tolerance to apply to HR Steel at .250
 
Replies continue below

Recommended for you

ASTM practice for plates (material 0.235" and thicker) is -0.01" / + 0.03" to 0.04" depending on width of plate.
ASTM A6 Table 1.
 
I might add that for pressure vessel use the thickness MAY go .010 undersize with no penalties -
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor