Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to use Tresca yield criteria for plasticity?

Status
Not open for further replies.

skrat

Student
Nov 29, 2021
2
SI
By default I assume that the ABAQUS uses the von Mises yield criteria when plasticity parameters are added to the material properties. Is there a way I could enforce the Abaqus to use the Tresca criterion?

I am struggling with it and I can't find a clear way to do it.

Thank you.
 
Replies continue below

Recommended for you

Abaqus doesn't have a built-in Tresca plasticity criterion. You would need UMAT subroutine to implement it.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top