Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to turn off wire harness centerline display in 2D drawing view
- Thread starter zydee
- Start date
RMB over view and select Properties. Select item in the list on the Display tab that has Tube centerlines. Right click over item and select "List Centerlines". Then click on the centerline and un-highlight "Show". Then update the view.
I wrote a VB6 program that will iterate through each view on the Active Sheet and hide all centerlines. I can send you this program if you would like.
I wrote a VB6 program that will iterate through each view on the Active Sheet and hide all centerlines. I can send you this program if you would like.
- Status
Similar threads
- Locked
- Question
- Locked
- Question